Spline-Based Boomerang in FreeCAD
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is pretty similar to the Red Oak design, although I made it from scratch.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 82
- Wydruki
- 0
- Wyświetlenia
- 440
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
This is pretty similar to the Red Oak design, although I made it from scratch. This one was created in FreeCAD 0.19, though.
The model basically consists of two spline loops for the top and bottom faces of the boomerang ("periodic splines", as FreeCAD calls them), and then a loft between those. If you want to play with the shape, just drag around some of the spline points.
FreeCAD is a little more stubborn than commercial CAD software, but then it's free as in "freedom" as well as free as in "free beer".
Print instructions
Resolution:
0.2 mm
Infill:
25%
Notes:
Use lots of perimeters, top and bottom layers for printing boomerangs. I usually go with 6 at .2 mm layer height.