Vine-Covered Sandcastle Topper
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Add to tops of sand castle for added fun!
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 102
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution
Add this topper to your sand castles for a little sweet detail!
This design uses a two-sided mold that can be filled with sand and pressed together. The model prints well at 5% infill. Print the model with the opening facing upwards to avoid supports. The vines are a little hard to see if printed at 100% scale, so 105-110% should make them visible in the sand.
P.S. If you're looking to save material, don't scale the model down (you'll lose the vines altogether). Instead, reduce the number of ceiling and floor lines. You can also enable gradual infill and set the steps to around 3-4 to reduce time and material.
Happy printing!