1 / 1
Polaroid Pathfinder 110a/800/150 Lomograflok Conversion - DELUXE version — zdjęcie 1

Polaroid Pathfinder 110a/800/150 Lomograflok Conversion - DELUXE version

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Convert a Polaroid 110A, 800, or 150 to shoot Instax Wide (right-side up!) by using a Lomograflok back.

Ocena
5 / 5
Polubienia
52
Pobrania
434
Wydruki
5
Wyświetlenia
3540
Oceny
4

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

You might be familiar with my original conversion. Well, I've since made a version that replaces the top cover of the camera with a custom 3D-printed design that allows clearance to eject Instax Wide the right way up. It even has just-about spot on framing through the viewfinder.

Note: This does not fit the 110B! I still need to get around to designing a top cover for that model.

It's a little more involved than the original conversion, but not too difficult. To start with, see the original build guide for: replacing the infinity stop & calibrating the rangefinder.

To replace the top cover, you need to:

  • Remove the parallax correction mechanism, we won't be needing it


     
  • Transplant some of the optics

        
     
  • Use two M2x4 and one M3x4 heat-set inserts

  • Screw it all in place! Make sure you do this after you calibrate the rangefinder, of course
  • There are spots with threaded holes for screwing in two SmallRig (or similar) cold-shoes on the top of the cover

The rest of the conversion is straightforward. Put some light sealing foam (1.5mm) between the bracket and the body, and screw the bracket in place using a ¼-20 screw. Some cameras have a thin metal ridge along the bottom that you'll need to bend out of the way for the bracket to fit snugly.

Slide in the Lomograflok, and secure it with a shorter ¼-20 screw. I just use this set from Amazon.

There's a threaded hole in the bottom to screw in (and glue in place) a 1/4" female to 3/8" male adapter, so you can use a tripod.

This conversion only uses one grip on the left. That's also easy to install, just pop it in and slide the steel rod through the holes to keep it in place.

And that's it! Enjoy these incredible cameras, and thanks for keeping them alive.

Tagi