Cable Zipt Tie Organizer/ Holder Collection
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Some Holder I recently designed to install all the cables of my friends Camper.
- Ocena
- 5 / 5
- Polubienia
- 305
- Pobrania
- 693
- Wydruki
- 11
- Wyświetlenia
- 3213
- Oceny
- 9
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Heyho
Here you have a collection of Holder to tame your Cable jumble :D
I Printed mine with ASA, 0,2 mm layer Height, 0,6 mm Nozzle, 100% infill, 2-3 Perimeter.
Holder Selection:
Single, I, T, + Holder (3 mm Screw)
Width for the cable tie: 4,8 mm
Pyramid + Screw (S = 3 mm, M = 3,5 mm, L = 4 mm)
Width for the cable:
- S = 4,15 mm
- M =4,84 mm
- L = 5,3 mm
Pyramid + Double Sided Tape (Fast & Cheap print, less strength)
Width for the cable:
- S = 3,48 mm
- M = 4 mm
- L = 5,2 mm
I tested all Pyramid (S) and normal Versions to compare its strength.
No wonder: The screwed ones are far stronger. Only the Pyramid (s) got destroyed during the test with a crowbar :) With all other models or if layed through 2 loops of the pyramid, the holder survived the test and instead the cable ties broke.
The holder got only a small visible deformation after the cable ties broke:
Installation tipps:
a) You can use the holder in different ways. Eather to crowd 4 cable ties into the pyramid or Plus Holder or use 1-2 Cables and increase the strength of the holder this way.
b) You can scale the holder up/ down if you need special sizes.
c) Do not overtighten the screws. I used a torque around 5 Nm and it worked just fine.
Have fun and keep printin! :)