1 / 3
DERECHO: Short shroud for blizzard storm foam blaster — zdjęcie 1
1 / 3

DERECHO: Short shroud for blizzard storm foam blaster

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A 200 mm shroud that is an almost drop in replacement for the stock blizzard storm shroud.

Ocena
5 / 5
Polubienia
4
Pobrania
29
Wydruki
1
Wyświetlenia
356
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Outdoor Toys
Licencja
Creative Commons — Attribution — Noncommercial
This model should be considered in beta and has not been game tested. Feedback is appreciated :)
 
Overview

A 200 mm shroud that is an almost drop in replacement for the stock blizzard storm shroud. Only additional (and somewhat optional) hardware requirement is an M3 machine screw and nut that can be used to clamp the barrel down at the front of the shroud. 

Shorter 200 mm length should be printable on most printers with 220  * 220 * 250 build volumes and allows you to use SCARs with shorter barrel lengths. 

Currently the front opening is sized for 16mm OD barrels. 

I have the original barrel installed in the model photos to try and give a reference for the difference in length with the original shroud.

 

Printing notes

It may be helpful to use supports on the angled portion of the front of the pickletinny rail. Supports should not be used anywhere else. Avoid them around the M3 bolt clamp area as they can be very difficult to remove. 

Tagi