MP3DP V4 rail mount for BIQU H2VS Revo
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount to put a BIQU H2 Revo on the V1 Engineering MP3DP V4
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 27
- Wydruki
- 1
- Wyświetlenia
- 439
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Mount designed for the V1 Engineering MP3DP V4. Accepts the BIQU H2vs Revo or any other H2 version. Only tested with the Revo version.
Incorporates mounting holes for the EBB36 or EBB42 Can Bus adapter boards on the top.
Print orientation is standing on the end with the notch in the face plate. Prints with no supports on a tuned printer.
A few points. This is designed to mount to a MGN12H linear bearing. The screws to mount to the bearing are M3x8 screws. The screws to mount to the H2 are M3x10. THE H2 MUST BE MOUNTED PRIOR TO MOUNTING THE CARRIAGE TO THE RAIL CARRIAGE.
The BLTouch mount needs some spacers to adjust for the REVO. Mine required an extra nut between the mount and the BLTouch. The standard H2 should be fine. It is printed with the flat side down. No supports required. It is sandwiched between the fan and the heatsink to mount/