1 / 5
VPC Mongoost T-50CM Throttle Finger Lifts(Idle c/o and AB detents) — zdjęcie 1
1 / 5

VPC Mongoost T-50CM Throttle Finger Lifts(Idle c/o and AB detents)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Finger Lifts for the V1 version of the VPC Mongoost Throttle.

Ocena
0 / 5
Polubienia
5
Pobrania
52
Wydruki
0
Wyświetlenia
640
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

I could not find any good fingerlifts for the V1 version of the vpc throttle so I decided to design my own. It includes a gated idle cut-off which requires the fingerlifts to be lifted to get it from idle to cut-off and a afterburner detent which can be overcome either by lifting the fingerlift or pushing the throttle harder to overcome the detent(similar to the winwing super taurus throttle).

Requires additional hardware:

  • m3 x 16 SHCS 8pcs (m3 x 18 would work better if available)
  • m3 x 6 SHCS 4pcs
  • m4 x 10 BHCS 2pcs
  • m3 x 30 FHCS 2pcs
  • 684zz Bearings 2pcs
  • Assorted Springs 2pcs(whichever fits the right tension feel for you)
  • m4 washer 2pcs(optional)

Only the detent part requires support and should be printed on its side so that the layer lines do not hinder the smooth operation of the throttle. A brim is recommended for the finger lifts if your bed adhesion is not great.

The screws are all threaded into plastic so do take note not to overtighten the screws when assembling.

For the clamps be sure ensure that the correct side of the clamping part goes to the correct throttle lever. One of the holes are slightly larger then the rest to allow for the countersunk screw to pass through. The rest of the holes are smaller for the screws to thread into.

I mainly play DCS and a few setting have to be tweaked to get the detents to work properly. The dead-zone has to be raised to around 6% for idle to be idle in the game and saturation to be lowered to 98% for the afterburners to kick in at the right time.

I have also included the step and f3d file for anyone that wants to modify or tweak the model for your needs.

Have fun and happy printing!

Tagi