4 inch vent hose flange
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Flange to fit interior of 4-inch dryer hose. UNTESTED WITH HEAT
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 75
- Wydruki
- 0
- Wyświetlenia
- 551
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I'm using a dryer hose to vent cool air and fumes from my low-end paint booth to the outside, and needed a 4-inch tube to channel the air. I picked flexible dryer hose (which I think is only sold in aluminum in the US now). My hose came with screw-tightened end clamps.
The hose fit is just a little loose - I recommend maybe 101% or 102% sizing if you want a more snug fit.
I'll be taping this flange to thick plastic drop cloth for my paint booth with shipping tape. You could probably drill the corner areas if you needed a stronger attachment to something solid, maybe caulk or adhere with RTV silicone.
I will NOT be venting heated air, so have not tested it with heat from an actual clothes dryer.
Use caution in hot-air situations - dryer exhaust can get VERY hot, and this may not hold up, especially on the close-to-the-dryer end. If you printed in PLA, I'd assume it would NOT hold up to heat.
Assume that 3D-printed ANYTHING for the purpose of exhausting a heated clothes dryer will not satisfy your local building codes, nor your homeowner's insurance, until you know different.
I printed with my least-favorite color of PETG, infill 90 and coarse at .32mm layers. Warping was not a problem, and (printing with coasting) stringing was not excessive.