Sunlu S1 support for Kobra Neo
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Filament dryer support for Kobra NEO
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 81
- Wydruki
- 1
- Wyświetlenia
- 850
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
I wanted to dry my filaments before printing and also heat them up up to 50 degrees just to make sure there is no moisture. I've searched the whole web for this project and couldn't find any so I took some time to create one for you.
It's not perfect but for me works flawlessly.
In the pictures there are the first prototype which look weird and are not the same but this version is the revised one.
Comes with 2 cable guide ( holes ) for each bracket and a filament guide.
One support is mounted where the original screw for the filament roller is and the other one uses the screw holes the printer comes with.
I've used a PTFE tube to guide the filament to the extruder and since my PTFE tube is smaller than the hole used in the extruder I had to use a filament cleaner to stop the tube from going inside the extruder gears.
Can be mounted on either side LHD or RHD.
FILAMENT GUIDES:
there are 2 versions:
One that comes with the support and one that is mounted the same way as the support that uses the holes for the screws for the aluminum profile.
The filament guide it's a must as the PTFE might get stuck on the printer aluminum profile when the X axis is moving.
The filament guide from the middle support can be cut if its not working for you.
Please post below your makes and also please let me know what improvements I should do.
If you like my work buy me a coffee <3
https://buymeacoffee.com/neo3dprint
