1 / 1
Retainer for the axle nut of a MRP fork — zdjęcie 1

Retainer for the axle nut of a MRP fork

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Retainer for the axle nut of a MRP fork to keep the nut from rotating

Ocena
0 / 5
Polubienia
0
Pobrania
10
Wydruki
0
Wyświetlenia
95
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

The nut at the axle of a MRP Ribbon fork rotates as you screw in the axle. This is annoying as you have to find the correct position of the nut to have the axle lever in the desired position.

This retainer fits over the nut and keeps the nut from spinning. To use it, screw in your axle and set the lever to the right position. Then put the retainer over the nut, aligned so that the nose fits in the small cutout of the fork. You may have to correct the position of the nut a bit, because the nose can only fit in one of 12 positions.

The protruding ring at the retainer should be located at the outside. It helps to pull/remove the retainer.

I made it for my MRP Ribbon, but may work for other MRP forks as well. Please let me know if you can verify this with other models.

I printed that in PETG with a 0.3mm nozzle and 0.25mm layer height on my Prusa mini.
 

Tagi