Neptune 2 / 2S dual z drive synchronizing belt
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a synchronizing belt for dual z drive on the Neptune 2 / 2s.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 242
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
This is a synchronizing belt for dual z drive on the Neptune 2 / 2s. You will need:
2 x MF148zz
4 x M3 x 4mm screws
2 x timing pulley 22t 6mm that will fit an 8mm rod
1 x 630mm belt
1 x flexible coupling for z rod as per picture
You will also need a belt tensioner as seen on my set up.
The top cross bar bolts are long enough to accommodate the new parts and can be reused.
Easy to install but don't overtight the set up at first until you have everything set up properly.
Print Settings
Printer:
Qidi X-Plus 3
Rafts:
No
Supports:
No
Resolution:
0.25
Infill:
40
Filament:
any PLAany
Category: 3D Printer Accessories