Replacement clips for Shimano S-TEC certification plaques

Replaces the stock clips supplied with the S-TEC training certification plaques.

Shimano's S-TEC training comes with certification that allows you to earn certification plaques. These come with clips to hang them together, but they stick out the back quite a bit, so wind up sitting away from the wall. Also, the length of the supplied clips space the plaques farther apart so if wall space is at a premium, you might want to bring everything closer together. 

These clips snap into the holes in the plaques and don't stick out the back nearly as much, so the plaques sit closer to the wall. Also available in a compact version which shrinks the center-to-center distance by 10mm to bring everything closer together, which can be helpful if your wall space is at a premium.

Printing instructions

Material, layer height, infill, etc - whatever you want. No supports needed. I printed in clear PLA as I was trying to kill the remnants of that roll.

These should snap into place, which can be tricky with the differences in printer calibrations and filaments. I printed at 100% and they gave a little resistance when installing which made them pretty secure once they were in place. I suggest printing one and test fitting it, and adjusting the X/Y scale to get the fit you want. (Leave Z alone as that should be close enough)  Once you've got the fit you want, print 16 for the full set of S-TEC plaques and the top hanger.

If you also have the PBMA certification plaque, you can either hang that below one row or use two of the longer spacers to hang it in between like I've done in the photos.