iMini 510 Vape Replacement Shell
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My iMini 2 510 Weed Oil pen broke at the base, right below the heating element. I painstakingly recreated the shell…
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 51
- Wydruki
- 0
- Wyświetlenia
- 731
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
My iMini 2 510 Weed Oil pen broke at the base, right below the heating element. I painstakingly recreated the shell and added a ring across the top to try to stop stress in the spot it broke originally.
I have designed the canister half in a way where you could slide the element through still connected to the wiring. It takes a bit of force, and you can slightly stretch the part in order to slide the element down and feed the wires through nicely. The element fits in snugly and needs to be pushed in with a pencil (eraser side) or something similar. Make sure you orient the element correctly, as it is flat on one side.
Finally, I put a piece of packing tape over the inside of the button to make getting the board and everything back together easily.
Remember that the charging port has the smaller side face up!
Enjoy and please post makes if you use it!
TinkerCAD: https://www.tinkercad.com/things/dee6wOH9XG8
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
.12
Infill:
15
Filament: Hatchbox PLA Orange
Notes:
No supports needed, but print the battery piece on its side, as oriented. I used a brim on the canister side.
Category: Electronics