Earthquake M43 Carburetor Diaphragm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replaces a broken diaphragm on a two stroke carburetor.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 156
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution
I accidently put a hole into the carburetor's diaphragm on my tiller when putting a new primer bulb on. I didn't realize until the engine kept flooding. So I went to Fusion360 to see if I could make a temporary diaphragm by tracing the old one. The thickness of this model is 0.32mm. I printed it with a layer height of 0.12mm so it would print three layers. I used a glass bed so only the top layer needed some light sanding.
This is what I came up with. It should fit other engine that use the same carb. I tested it for two days to make sure it would still work over time. This is more of a temporary solution anyways and a new carb or rebuild kit should be purchased.
Settings:
- Layer Height: 0.12mm
- Infill: 100%
- Material: PETG (or other fuel resistant filament)