Sunflower Hook
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bathroom/toilet towel sunflower hook
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 52
- Wydruki
- 0
- Wyświetlenia
- 291
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial
I've broken one of my bathroom hooks and needed some Fusion360 project to learn so I made this sunflower hook to replace it. I'm very much a novice in F360 but it did print fine so no reason to keep it to myself.
Printed with 0.2 Layer height on a textured PEI sheet for a nicer look on the cap.
There are two heights for the leaves so if you want to you can make 3 filament changes with layers like:
0-20 green
21-25 yellow
26+ orange
or just
0-20 green,
21+ yellow like I did.
Ideally the bottom part with the hook could be whole green. This could also improve weight capacity but those were way too many filament changes than it was worth for a part mostly covered by a light towel.
Designed with ~8mm head, ~3.7mm diameter screw in mind. The normal cap was made with that in mind. I've added additional taller and less tolerant caps if anyone needs them.