Newtonian Astrograph - Printed Parts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Printed parts for a 6" newtonian astrograph
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 129
- Wydruki
- 0
- Wyświetlenia
- 1494
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Physics & Astronomy
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I printed some parts for my Newton Astrograph.
This astrograph is based on the TS-Photon 154/600 f/4 Newtonian telescope, identical in construction to a GSO 6".
I featured the astrograph on my blog and there were requests for the parts. Maybe there is something for you too :)
Here are all the details:
DE: https://astrophoto.lionbit.com/technik/23-newton-umbau-von-der-blechdose-zur-carbonkanone
The tube rings each require an aluminum part that is screwed to the tube ring. It is used for stabilization and safety. The aluminum part is a piece of 6mm plate (94x12x6mm) in which 3 threads have to be drilled. For my Vixenstyle rail, an M6 thread is required in the middle and the 2 outer M5 threads have a distance of 82mm. These 2 threads are required to screw this aluminum plate to the tube ring.
You can optionally insert M5 nuts into the rings for additional accessories.
The rings also need a layer of 1mm thick foam rubber on the inside, on top of which I glued a layer of thin felt. Thus, the telescope is held softly but securely and the plastic rings can shrink a little in winter without breaking.
The end rings have neodymium magnets 6x3, these hold the dust cover or the dew cap.
Happy printing!