1 / 3
Angel lights for rc crawler/model
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I wanted some interesting lights for my crawler and I designed these inspired by the iconic BMW lights.
- Ocena
- 0 / 5
- Polubienia
- 22
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 542
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (22)Powiązane
The files are split based on the filament needed.
in the opaque parts you have the iris and two variants of the case:
- a round one
- one that has a mount that uses an m3 screw (you will have to mirror along x or y to get both sides).
The translucent part is the insert that will let the light shine through (I used translucent PETG, without any tint and a red light to get the effect in the pictures).
Prerequisites:
- translucent filament
- opaque filament
- 5mm round LEDs
- M3 screws if you print the variant that has a screw mount
- transparent glue (superglue)
Instructions:
- In prints without supports in the provided orientation, the resolution isn't relevant, the models do not have fine details.
- Print the translucent part at 100% infill, the light will be more consistent.
- The easiest way to assemble is to put a bit of glue on the chamfered edge of the translucent part and insert it into the case. Drop a very small amount of glue (if you use more it will spill out) in the space left for the iris and place the iris on top.
- depending of the tolerances of the LEDs you might need to either enlarge the hole with a drill or glue it in place or (if you are really lucky) the LED will friction fit.