GPS GY-GPS6MV2 MODULE CASE NEO-6M

I design this housing for GY-GPS6MV2 module.

Description

The module allows you to add GPS support in a microcontroller system (eg Arduino ), and the built-in NEO-6M system gives great possibilities and ensures high precision of measurement. The module has a built-in cell supporting RTC clock settings.

The GY-GPS6MV1 module is a board containing the U-blox NEO-6M GPS receiver system. The tile also includes RTC backup battery, antenna connector (U.FL), voltage stabilizer and UART signal outputs.

properties

• GPS system: U-blox NEO-6M
• Transmission type: UART (lines Rx, Tx)
• Received band: L1 (1575.42MHz)
• Positioning efficiency: 3 m on average
• Drift: <0.02 m / s
• Reference system: WGS-84
• Maximum height: 18.000 m
• Maximum speed: 515 m / s
• Acceleration: <4g
• Tracking sensitivity: -161 dBm
• Sensitivity of acquisition: -148 dBm
• Average time of "cold start": 38 seconds
• The average "warm start" time is 35 s
• Hot start time: 1 sec
• Average recovery time: 0.1s
• Working temperature range: -40 ° C to + 80 ° C
• Power supply range: from +3.5 V to +5.5 V
• Bus voltage UART: 3.3 V
• The soldering points allow the antenna to be mounted on the PCB
• Built-in RTC backup battery
• Built-in u.FL connector for antenna
• Module dimensions (without antenna): 36 x 26 x 4 mm
• Dimensions of the antenna: 25 x 25 x 8 mm

Included

• The GY-GPS6MV2 module
• Antenna with u.FL connector

This video shows an example usage of this module:

If you need help or you want to be printed this parts or customized in different way, just send me a message here on Printables, I can ship worldwide and I promise very good quality prints.

I appreciate if you will give me a donation, so I can bring my ideas forward: https://bmc.link/engineeringprojetcs .

Thank you to support me and happy printing.