AnkerMake M5C Filament Guide Rear Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
M5C filament guide/ptfe tube guide for rear mounted spools.
- Ocena
- 5 / 5
- Polubienia
- 53
- Pobrania
- 423
- Wydruki
- 1
- Wyświetlenia
- 2727
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I'm using my M5C with the filament spool at the rear and the included filament guide doesn't work well with it. I really like the original model by just_trey so i made a remix that works better with rear mounted spools.
There are two guide models, one that goes “over” and one “under” the top of the frame. PTFE tube goes into top, filament in the bottom, you can reuse the clip/clamp from the included filament guide.
I also made a brace in case the filament guide slightly cracks when putting it on the printer frame. Print the brace at 101% otherwise it might be a tight fit. (Slim model is slightly thinner, but support is not as strong.)
Both models work with PLA, but will work better with PETG since they need some flex.
(Note: Mounting the spool at the rear will limit compatiblity for very big models that cover the whole bed while also exceeding the height of the spool. But for most models it works perfectly fine. Not an issue with small 250g spools.)