Bambu Lab Hotend Mount for Neptune 3 Pro/Plus/Max
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These parts enable you to switch from the factory hotend to a Bambu Labs hot end.
- Ocena
- 0 / 5
- Polubienia
- 45
- Pobrania
- 207
- Wydruki
- 0
- Wyświetlenia
- 3148
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
All parts printed with PETG or ABS with support for the fan ducts.
Printed Parts:
- T Piece
- Fan Duct LH
- Fan Duct RH
Optional Parts:
- Fan Duct RH (no level sensor)
- Level Sensor Mount - If you'd like to mount it elsewhere. As I am using linear rails I had space on my tool head carriage plate.
- T Piece (Short) - If you're screw isn't quite long enough or you're using BHSC.
Required parts:
- Bambu Lab Hotend or clone for X1-C or P1P
- 2510 24V Hotend Fan
- 2x 5015 24V Fans
- 2x M3x15mm SHSC (16mm or longer will work too)
- 3x M3 Nuts
Level Sensor Offset:
- X: -34.292mm
- Y: 20.682mm
PTFE Tube Lenght:
- 34.1mm
Z Height reduction (compared with hotend):
- 14.75mm
Please note that for the JST PH terminals for the fans, Elegoo switches the polarity on their connectors (red is still positive but just on the opposite side). Just take a look at the stock fan connectors first to save yourself some hassle.
The heating element for the Bambu Lab hotend is plug and play, however the thermister plug requires replacing with a JST PH 2.0mm.