Feather Board for DeWalt Table Saw 7491 & 7492
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of two designs to get the best of both for my DeWalt Table saw with metric nuts and bolts.
- Ocena
- 4,8 / 5
- Polubienia
- 200
- Pobrania
- 1215
- Wydruki
- 9
- Wyświetlenia
- 4687
- Oceny
- 10
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
This is a remix of two designs to get the best of both for my DeWalt Table saw with metric nuts and bolts.
Following Designs are used:
Sliding Block:
www.thingiverse.com/thing:3973092
The block was dapted to fit for the DeWalt 7491 & 7492 and the size of the hex nut was adapted for a metric M8 hex nut.
Feather Bord
www.thinagiverse.com/thing:2832564
The legs of the board are extended. The Knob is adapted for a metric M8 hex bolt.
Notice: for the sliding block I enable the PrusaSlicer Ironing feature (for test purpose) looks very nice. One picture shows the same Block with and without ironing. I love this feature.
Print instructions
PETG
40% Infill
0.3mm layer height
Ironing (partiel)