Milk Crate for Skadis - no supports
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
three sizes of a little milk crate to put on skadis boards without the need of supporting the hooks
- Ocena
- 4,5 / 5
- Polubienia
- 84
- Pobrania
- 424
- Wydruki
- 5
- Wyświetlenia
- 1596
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
this remix of the Milk Crate by Bupher is my attempt of putting it on skadis boards without the need of support material for the hooks. (mostly worked out as far as I can tell, only tiny overhangs that are not exactly bridgeable but not affecting functionality)
i prepared sizes S (80x80mm outside), M (100x100mm) and L (120x120mm), you can choose from versions with a closed bottom or the open/barred one.
the hooks print separately also without support in two versions, labeled “minus“ fits for uncolored skadis boards, „plus“ for black/white ones. crate size S needs 3 hooks, sizes M and L need 4. use your favorite strong options when printing them.
be aware of two issues: if your printer is not tuned well or your filament isn‘t fully dried this model is a nightmare from stringstreet (thats why I didn‘t show my testprints so far) and it‘s not capable of “high“ loads due to the thin overall structure.
as always I highly appreciate every like, rating or make, same for remixing and sharing.
donations will be forwarded to sea-watch.org