1 / 3
Ständer für Rasierpinsel / Stand for shaving brush — zdjęcie 1
1 / 3

Ständer für Rasierpinsel / Stand for shaving brush

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A stand for shaving brushes, designed for a "Mühle" brand brush but can also be used for other brushes.

Ocena
5 / 5
Polubienia
5
Pobrania
37
Wydruki
1
Wyświetlenia
280
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Bathroom
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Deutsch / English

Dies ist ein Ständer für Rasierpinsel, designed für Pinsel der Marke Mühle, aber auch für andere Pinsel mit vergleichbarem Griffdurchmesser verwendbar.

Ich nutze ihn in meinem Bad schon seit längerer Zeit, damit die borsten meines Pinsels gut abtropfen können und der Pinsel lange schön bleibt.

Die Kappe, der Halter und die Schale  wurden Gedruckt ohne Support, ich empfehle Stützen bei der Säule zu aktivieren, zumindest an den beiden Enden , es sollte kein Kleben nötig sein zum Zusammenbau. 
Die Schichthöhe ist zwischen 0,1 und 0,2mm wählbar, bei meinem Druck betrug sie 0,1mm um eine schönere Oberfläche zu erhalten. 

Als Filament wurde Black PLA gewählt

Das Design ist passend zu meinem Rasierhobelständer gewählt: 
https://www.printables.com/de/model/298557-stand-for-two-safety-razors-halter-fur-zwei-rasier

Ich würde mich über Kommentare und Makes freuen!

Happy printing!

/

This is a stand for shaving brushes, designed for Mühle brushes, but can also be used for other brushes with a comparable handle diameter.

I have been using it in my bathroom for a long time so that the bristles of my brush can drip off well and the brush stays beautiful for a long time.

The cap, the holder and the bowl were printed without support, I recommend to activate supports at the column, at least at the two ends, it should not be necessary to glue to assemble. 
The layer height can be chosen between 0,1 and 0,2mm, for my print it was 0,1mm to get a nicer surface.

I have chosen Black PLA filament

The design is chosen to match my razor stand: 
https://www.printables.com/de/model/298557-stand-for-two-safety-razors-halter-fur-zwei-rasier

I would be happy about comments and makes!

Happy printing!

Tagi