LTT 21oz Water Bottle Sleeve/Boot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Just a basic bottom sleeve/boot for the LTT 21oz Water Bottle
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 286
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Coming from a Hydro Flask with the extra Sleeve/Boot i created my own quick and dirty sleeve for the 21oz bottle.
It offers a little extra protection, nice contrast and dampen the sound of placing it on a hard surface.
I also added a little venting hole for easier time putting and taking it off and to let moisture out.
It got a tight but not too tight fit, it just works.
Printed on a BambuLab P1P using these overall settings:
- Filament: Overture 95A TPU in Black
- Nozzle: 0.4mm
- Layer Height: 0.20mm
- Wall Loops: 2
- Top Shell Layers: 4
- Bottom Shell Layers: 3
- Infill: 20 %
- Infill Pattern: Concentric/Gyroid
Based on my test prints the gyroid tends to be a bit more firm compared to the concentric infill that still firm while standing, but has a little more give putting the bottle down.
So: Gyroid firmer, concentric squishier.
You going to find two .3mf Project Files with either a concentric or gyroid infill pre-selected and some other fine-tuned settings.
The overall .3mf Project files are based of @RolandDeschain Bambu Lab Overture Process Profiles which, for me, created pretty good results.
Follow this for the Filament Process Profiles: https://www.printables.com/model/463757-overture-tpu-filament-and-process-profiles-bambu-l
Like i said it is nothing too fancy and just my first steps creating my own models.
I hope you like it and stay hydrated!