Ender 3 S1 Rolling Spool Holder (6000Z Bearings)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A printable version of the stock Ender 3 S1 Pro spool holder. Individual parts are compatible with the original parts.
- Ocena
- 4,875 / 5
- Polubienia
- 104
- Pobrania
- 505
- Wydruki
- 8
- Wyświetlenia
- 3094
- Oceny
- 8
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This model is based on the Creality Ender 3 S1 Pro stock spool holder. Each part (tube, caps, shaft) is designed to be compatible with the original holder to allow for partial replacement or modification.
Required Hardware
This holder uses same hardware as the original:
- 2x 6000Z bearings (that is ID 10mm x OD 26mm x W 8mm), ABEC 1 is sufficient. Printed bearings might also work
- 2x M4 screws with a maximum length of ~16.5mm, longer screws preferred to increase strength
Printer Settings:
I have successfully printed the model in PLA using a 0.4 nozzle and 0.2mm layer height with the following changes to the standard profile:
Tube: Use random seam position to avoid getting a small bump every rotation. Additionally turn on scarf joint seams if you are using OrcaSlicer. If you have difficulties with bed adhesion, use a brim.
Cap: Standard settings work fine.
Screw cap: Turn on supports.
Outer shaft: If you have difficulties with bed adhesion, use a brim.
Inner shaft: This is a thin load bearing part, so make sure to use 6 perimeters/walls and 6 top/bottom layers (= 1.2 mm thickness). Use a high-strength material if possible.
⚠ Caution: Using these recommendations this part should hold a 1kg spool with ease. Please note that PLA creeps under load and I have not done any tests to see if it holds up long-term.
Links
If you liked this, check out my take on the stock spool holder mount: https://www.printables.com/model/472450-ender-3-s1-spool-holder-mount
For a fully printed alternative I recommend https://www.printables.com/model/380847-ender-3-s1-pro-secondary-spool-holder-fixed