Zenni 550021 Cyber Eye
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I had spare Zenni 550021 frames from harvesting lenses for VR headsets. This design clips WS2812 rings onto the frame.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 306
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Share Alike
I had spare Zenni 550021 frames from harvesting lenses for VR headsets. This design clips on to the frame (without lenses) and takes a 16 LED WS2812 ring like the one linked below
Note that not all rings share the same dimensions.
There are slots for routing wires out of the LED ring.
The “film” stl is intended for printing in transparent filament to go over the LED.
I have additionally uploaded a clip without walls for drawing or mounting anything else you'd like.
Test prints were done in PETG, except the film done in ABS.