1 / 9
Filament Guide : Twin-Pulley for Creality + Gear Extruder — zdjęcie 1
1 / 9

Filament Guide : Twin-Pulley for Creality + Gear Extruder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

► Low-friction twin pulley design allows filament reel either above or below. ► Nozzle keeps filament clear of Z-screw

Ocena
0 / 5
Polubienia
2
Pobrania
30
Wydruki
0
Wyświetlenia
302
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

I changed the extruder on my Creality to a twin-gear type, and my old filament guide (552350) didn't fit any more.

Here's the new one.

The extruder appears to be a Bondtech clone, and the entry hole is 19 mm above the Z-backet.

The guide attaches to the Z-bracket using the same screws as fasten the Z-Nut (on my printer these had sufficient spare length).

The twin pulley arrangement allows the filament reel to be located either above or below the printer.

the nozzle keeps the filament clear of the leadscrew. When installing, take care to align the nozzle accurately.

Although the CR20 is very similar to the more common Ender-3 (and possibly other Creality models), I've not tried it with them. It's possible that the pressed steel bracket can vary somewhat from machine to machine. Although I gave some leeway in the design I can't guarantee it will fit. But it's not a large item to print and try.

You need:

2 x U604 Pulley Bearings

2 x M4 x 12 Screws

2 x M4 Nuts

Category: 3D Printer Accessories

☻

FreeCAD source model included 

Tagi