1 / 2
Orings for 24/30mm holes, Kailh v2 — zdjęcie 1
1 / 2

Orings for 24/30mm holes, Kailh v2

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Orings compatible with a 24 and 30mm hole to allow for sliding on any device using caps on switches (ie flatbox)

Ocena
5 / 5
Polubienia
24
Pobrania
102
Wydruki
1
Wyświetlenia
857
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Video Games
Licencja
Creative Commons — Attribution

Update : 

- Added 30mm variant with 26mm button
- Slightly reduced the fillet on the button after noticing some failures

25/08  : 

- Slightly changed the fillets following inconsistencies after an orca update
- renamed files properly to the corresponding hole


The goal was the be able to slide my finger on the directional buttons for the supers in GG strive.

The oring + button step file is in printing position (top facing the plate) for both, should print in place without touching and makes the overall print easier

The caps are made to fit on Kailh choc v2 switches

I printed this on a P1P with default settings with a 0.1 layer height, lots of cooling for the fillet.

Rings should be a pressure fit, i recommend setting them before assembly so you can slightly bend the top if needed to get the rings in easier.

Might want to scale down the buttons or check your solders (Hotswap not being straight) if you get the cap stuck on the way up after pressing/sliding

Good neutral and have fun !

 

Tagi