Bamboo Dart Mold/Maker Nerf
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I improved a single dart mold to mold to four dart mold in order to DIY some more bamboo darts.
- Ocena
- 0 / 5
- Polubienia
- 23
- Pobrania
- 109
- Wydruki
- 0
- Wyświetlenia
- 845
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
I only have made a four dart mold of the tight fitting 3 ring model, if you want other models as a four dart mold from the original model then comment which one and I will get it done as soon as possible!
To use the four dart mold push the darts bottom side down into the mold then, either wait 12 hours or use a hair dryer to heat it up, I found that 35-40 worked for the hair dryer I was using. Wait until the outside of the mold is at room temperature then pull then out by the head.
Pro tip #1 use needle-nose pliers to hold the mold while it's being heated
Pro tip #2 If a newly bambooed (is this a word?) dart is really stuck the try pushing on the bottom of the stuck bambooed dart
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 V2
Resolution:
.2
Infill:
Doesn't matter
Filament: Overture Petg Black
Post-Printing
I used a pocket knife to clean up the inside probably from using PETG.