Sides for RepBox + Repwinder (to fully use enclosed RepBox)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Repwider side optimized to fit in RepBox with Slip Rods. Comes in & out WITH spool attached. Can print 2 sides at once.
- Ocena
- 5 / 5
- Polubienia
- 2
- Pobrania
- 26
- Wydruki
- 1
- Wyświetlenia
- 304
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
This provides replaces the sides for Repwinder to use modified sides (inspired by RackStand).
The sides are small enough that two will fit on the build plate (see 3mf - if using the STL split it into objects and rotate one side by 180 degrees to be able to fit).
These sides have a finger hole near the top which makes pinching the Repwinder into the top of the rack easier.
The rack first lowers onto the back slip rod and then sets on the front slip rod. It is easy to insert and remove the stand with a full spool and Repwinder, even in a full RepBox.
Should print with most any settings you choose. I did nothing fancy for printing: 0.20mm QUALITY, with variable layer height “Adaptive 0.50”, quality, no supports, 15% infill. Printed well on both MK3S+ and MK4.
Rationale for my design:
The original Repwinder design fits best in a Repbox with no slip rods (although they will set in with the slip rods - it is not very tidy that way).
The original Rackstand design cannot fit in an enclosed RepBox with a spool loaded on the Repwinder (required before placing in the box) when you want to fill all RepBox positions.