Charging Stand for Fossil Q Explorist
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Based on the Fossil Q Explorist Charging Dock by Samrobmoe you'll see the similarity in the part the watch sits on.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 47
- Wydruki
- 0
- Wyświetlenia
- 433
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Public Domain
Based on the Fossil Q Explorist Charging Dock by Samrobmoe you'll see the similarity in the part the watch sits on.
This design has the watch at a 20 degree angle so the magnet in the charging pad is enough to keep it from sliding off. There's also a clip feature to hold the cable in the loop under the watch. The base is a bit smaller.
This is intended for the Fossil Q Explorist. The charging pad recess is 26mm diameter x 4.6mm deep and the cable slot is 4.5mm wide. The cable clip is meant for a 2.8mm diameter cable.
Print instructions
Category: Gadgets Summary
Based on the Fossil Q Explorist Charging Dock by Samrobmoe you'll see the similarity in the part the watch sits on.
This design has the watch at a 20 degree angle so the magnet in the charging pad is enough to keep it from sliding off. There's also a clip feature to hold the cable in the loop under the watch. The base is a bit smaller.
This is intended for the Fossil Q Explorist. The charging pad recess is 26mm diameter x 4.6mm deep and the cable slot is 4.5mm wide. The cable clip is meant for a 2.8mm diameter cable.
Print Settings
Printer Brand:
Prusa
Printer:
Prusa Mk2
</div>Rafts:No
Supports:
No
</div>Resolution:0.2
Infill:
15
</div>Notes:
Printed with 0.6mm nozzle at 0.2mm layer height with 3 perimeters and 15% infill. Would probably have been fine with no infill. Took 3 hours to print.
It should be printed on its side without any support.