Sentinel Inductive Probe [2020]
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Get that perfect first layer!
- Ocena
- 0 / 5
- Polubienia
- 22
- Pobrania
- 70
- Wydruki
- 0
- Wyświetlenia
- 1045
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Get that perfect first layer with a simple inductive probe! No loss in printable space, installed in just a few minutes.
Please be aware that this only works with a metal print-surface.
Im using the endstop from a sidewinder X1, but you can buy the probe from aliexpress HERE (GX-H8A)
Im using the E0 plug on my SKR mini board, both the V2 and V3 have the same pin number.
I've included a config HERE to get you started, remember to add BED_MESH_CALIBRATE to your start macro
Installation is fairly simple, bolt the probe to the printed part and the printed part to your hotend-fan, make sure the probe is about 1-2mm higher than your nozzle, plug the sensor into E0 on the SKR mini E3 V3 and run the probe_calibrate command to set your z-height.
(if not using the skr mini e3 v3, you need to change the pin in the config)
Like my work? Support me on Ko-fi!