Pot Noodle Lid for Kratky Method grow pot, 32mm hole
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This lid allows you to reuse an old Pot Noodle container as a pot for growing plants using the kratky method. The hole…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 203
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
This lid allows you to reuse an old Pot Noodle container as a pot for growing plants using the kratky method. The hole is 32mm to fit a net pot, the ones I bought were described as 1.5" pots. There is a small ridge so it clicks around the rim of the pot. Print in the orientation shown in the picture.
I recommend using a relatively heat resistant filament, direct sunlight (if hot enough) will cause PLA to warp. Use ABS or some other filament that will resist warping in heat if that is a problem.
Paint or otherwise cover the pot noodle container since light getting through it can cause unwanted algae growth in the nutrient solution. I used grey primer followed by chrome spray paint.
Category: Outdoor & Garden