Batman - Gotham by Gaslight (pre-supported)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A bust of Batman - Gotham by Gaslight.
- Ocena
- 5 / 5
- Polubienia
- 179
- Pobrania
- 990
- Wydruki
- 8
- Wyświetlenia
- 4451
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Sculptures
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This guy has two Variants, as pictured below. V2 has a "tighter" cut so it can be printed larger, and on FDM it shouldn't require any supports as all:
Printing instructions - resin
Pre-supporting files is a royal pain in the ass! Especially when there's so many versions. I certainly hope it's of use to some of you out there 😅 I have included Lychee slicer (the best slicer, right?) Lite files, as well as pre-supported STL files (zipped in the Other Files section). As in the previous release it comes in SMALL (e.g. Elegoo Mars) and MEDIUM (e.g. Elego Saturn, Anycubic Mono X) formats. Larger printers are still uncommon enough that it's not really worth the time it takes to presupport the files for such a small userbase, so (for the time being) you will have do those yourselves!
Again, I have made sure the Lychee files are easily editable with supports tagged for the various uses (perimeter, internals, middle (which I probably should rename "bottom", etc), so if you do find my supports a bit crappy you might not have to start from scratch and can edit them instead.
FDM instructions
For Variant 1 you will have to add supports around the entire model to support the cape (as depicted in the image below). In hindsight maybe I shouldn't have designed it that way, but it is what it is! So if you have an aversion against supports I recommend Variant 2, which should require no supports!
