1 / 8
Cover of AstroTrac 360 mount for ONSTEP conversion — zdjęcie 1
1 / 8

Cover of AstroTrac 360 mount for ONSTEP conversion

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a cover of AstroTrac 360 mount for ONSTEP conversion (without encoder functionality)

Ocena
0 / 5
Polubienia
2
Pobrania
9
Wydruki
0
Wyświetlenia
168
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v2.0

AstroTrac 360 is a nice & elegant little mount with excellent design, which is a piece of art in itsef. However, due to the lack of the ASCOM driver, it is difficult to be connected & controlled by NINA for astrophotophy. 

The is a cover for AstroTrac 360 mount when controlling its stepper motors by ONSTEP.  To proceed this conversion, one needs to remove the original controller PCB first. And after removal, it remains a nema17 stepper motor (17HM08-1204S) with a 4-wire connector & an encoder (Renishaw A-9405-4050). It is straightforward to connect the 4-wire connector of the stepper motor to a CAT3 keystone jack. 

For this new cover, the 12V power-in & ST4 outlets are omitted, since stepper motors can get the required power from signal lines & ST4 is seldom in use nowadays. Note that the functionality of the built-in encoder has not yet been applied in this conversion. 

Finally, for ONSTEP firmware modification, the following info is applied.

Note that with the above setting, the actual maximum goto speed (with 10kg loading) is about 5 degree per second (around 800X), and the PHD2 tracking RMS is around 0.5" (with minimum around 0.3" for a telescope of 500mm focal length).

Tagi