1 / 3
BMW R1150GS Adventure tank guards v0.3 — zdjęcie 1
1 / 3

BMW R1150GS Adventure tank guards v0.3

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Tank protector for BMW R1150GS Adventure (not applicable for non-Adventure) tank guards.

Ocena
0 / 5
Polubienia
6
Pobrania
92
Wydruki
0
Wyświetlenia
1099
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Share Alike

BMW R1150GS Adventure with the 30 liter tank tends to get nicked when you “have to lay ‘er down”. There were aftermarket tank guards available by Touratech, but they aren’t manufactured any more and very hard to get second hand.

WARNING: The v0.3 is still a draft and isn't fitting 100 % in the front upper corner – there's about 5-10 mm gap. 

How it performs?

Haven't yet used it in a crash – results to be done. My expectation is that it won't survive a rough fall, but it should at least protect the tank.

Printing and post-processing

I've used ASA with 3 perimeters, layer height 0.2 mm and 20 % infill. Post-processing was done in three phases:

  1. Sanding
  2. Acetone smoothing. I haven't used the usual vapour method – just rubbed acotone soaked rug on the surface.
  3. One layer of XCR Epoxy Coating Resin – probably should have done another sanding step before as the epoxy wasn't sticking to some parts well.

Mounting

Mounted on transparent silicone – couple of vertical strips to allow water flowing down between guard and tank.

Tagi