BMW R1150GS Adventure side stand extension

I've bought Marselus R1150GS sidestand extension, but it's designed for the non-Adventure R1150GS. The Adventure has a different footprint. This model reuses two (middle and bottom) out of three stainless plates + mounting hardware from the Marselus product. A part of the original extension is replaced with printed adapter, which fits the Adventure sidestand footprint.

Also the sidestand extension is slightly rotated, so it won't collide with the central stand when both of them are folded during ride.

How it performs?

Survived 7000 km, after that I had a minor slide in mud, landing on the side stand. The print cracked a bit and became loose, but still functional. Printed a second one.

Printing and post-processing

I've used PLA and ASA with 3 perimeters, layer height 0.2 mm and 20 % infill. Don't add too much infill/perimeter – heavier the extension is, the more will it bounce during ride. 

Completion

1. Take the bottom plate from Marselus extension, install screws
2. Put the bottom model on the plate
3. Put the middle model on the plate
4. Slide the middle (the framey-looking one/the one with largest hole) Marcelus plate on your sidestand.
5. Mount the assembled part from 1-3 on the sidestand footprint
6. Mount the top model on sideplate
7. Install screws, join all 3 printed + 2 stainless plates together.