1 / 4
Apogee shroud for Ender-3 V2 Neo & Micro Swiss Hotend — zdjęcie 1
1 / 4

Apogee shroud for Ender-3 V2 Neo & Micro Swiss Hotend

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Apogee shroud modification for an "Ender-3 V2 Neo" with a "Micro Swiss hotend"

Ocena
0 / 5
Polubienia
25
Pobrania
94
Wydruki
0
Wyświetlenia
2004
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is an Apogee shroud modification for an "Ender-3 V2 Neo" with a "Micro Swiss hotend" (not usable with the original Neo hotend).

Unlike the original Apogee shroud, this modification leaves the CR-Touch mount on the left side. This also means that no further adjustments are necessary!

 

My printing recommendation for the base plate:
- PETG or better (heat resistance)
- Perimeters: 3
- Top/bottom solid layers: 4
- Infill: 20%
(just try it)

 

Additional material needed:
- Orbiter v2 (of course)
- 2 x 4010 blower (24V)
- 1 x 3010 axial fan (24V)
- 2x M3 L10 Hex drive button head screw
- 3x M3 L15 Hex drive button head screw
- 2x M3 L20 Hex drive button head or countersunk head screw
- 7x M3 thin square nuts (1.8mm max thickness)

For more information check the website https://www.orbiterprojects.com/apogee-ender-3-v2/


Credits goes to 
- Robert Lőrincz for the Orbiter/Apogee project!
- Marin Tamás for his Ender-3 V2 Neo modification of the base plate


For more information check the orbiterprojects.com website or the Facebook Group (https://www.facebook.com/groups/705637896767655/)


Bonus material:
- Cable strain relief for the Orbiter/LDO motor

Tagi