1 / 2
Lightsaber RP2040 Tighter Fit Blade Holder for Ultrasaber blades — zdjęcie 1
1 / 2

Lightsaber RP2040 Tighter Fit Blade Holder for Ultrasaber blades

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

My Ultrasaber Blade was loose within the blade holder

Ocena
5 / 5
Polubienia
17
Pobrania
109
Wydruki
1
Wyświetlenia
635
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Props
Licencja
Creative Commons — Attribution — Share Alike

The blade holder when printed was loose on my Ultrasaber 24" blade so much there was a gap around the blade and the emitter would not tighten against the blade. 

I modified the original Blade_Holder STL as well as the Blade_Holder (Short) STL to have an internal diameter of 25.4mm. This gave pretty much an interference fit against my blade and now the emitter locks the blade in place.

Hopefully if you find you have a slightly smaller diameter blade, these holders will help you out.

 

Update: It was pointed out that I had uyploaded both as 28mm tall versions, this has now been addressed. Thank you Mark Tomlinson for discovering my error.