Gridfinity Speed Square Holder (Universal 4.5" square holder)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Gridfinity holder for any 4.5" speed square (aka rafter square, carpenter's square, framing square, triangle square)
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 63
- Wydruki
- 0
- Wyświetlenia
- 1064
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
I designed this 4x4 gridfinity holder to hold my 4.5" speed square.
It's 3 units high but the top lip of the square sticks out a bit, so it's probably 4 units high, realistically. Being only 4 units high, it should fit in any toolbox drawer.
I haven't tested other squares (the Milwaukee 4.5" square or the Johnson one) but I designed this model with enough wiggle room, so they should fit just fine. If they don't, let me know so I can update the model :)
Want more?
- Check out my single or dual 6" combination square holders
About the print in the photos
- Nozzle: 0.6mm
- Layer height: 0.4
- Infill: 15%
- Walls: 2
- Top/bottom layers: 3
- Print time: ~5.5 hours
Onshape source file (even better than the STEP file): Here
If you remix this, just give me some attribution <3