Rook Evolution rear switch panel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remix of a rear switch mounting panel that throws a couple of tweaks to the mix
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 179
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of the rear panel to house a power switch on the back of the Rook Evolution printer.
Here's the list of changes I made:
- Allow for the panel to be screwed from below, like the original screws are screwed in. This adds exactly 4mm of thickness, so the original 10mm screws can be replaced by 14mm screws and nothing will change.
- Remove the unnecessary coin slot, as it's meant for the front and has no purpose to be on the back.
- Replicate the diagonal stripes pattern instead of the above.
Post-installation
I found out that due to the switch panel being on the side, plugging in and out creates a lot of stress on the part and it flexes quite a bit.
The solution was to add some hot glue on the sides to attach the part to both legs.
Hot glue is perfect for this particular job because it's sticks strong enough to hold the part for not-too-agressive push and pulls of the cord, and on the other and it can be easily peeled off in case some maintenance on the printer is required.