Zettelkasten Index boxes (Slip Box)

Introduction

This model has been specially developed to take full advantage of the printing bed of most printers, which is approximately 200x200 or a little more.

but it can also be used for anything else, with saving writing material, drawing etc. 

• This gray module you see is specific to 100x150mm index-cards (4x6 inches). To get an idea of the dimensions, it allows you to put a little more than 700 cards of 180g/m^2

Of course, in the case of a modular system it is possible to accumulate as many modules as you need, that is, the system will grow according to your needs.

You can use colors for each of the groups, thus organizing your workflow.

Printing

These cards are the second largest, and so as you can see the boxes are not small either (like I've said in the beginning, they use almost all the print bed area (PRUSA MK series). You will have to wait a few hours before you can use your slip-box, but you will get it and it look fantastic. If you want other dimensions send a message, or change this to your needs.

It is however a remarkably simple impression, without supports, without anything special. The infill is up to you, the default 15% is ok.

Change Log

(2308-2023) Added a little more hight to allow for tabbed cards - thanks to Professional_Chart52 from Zettelkasten subreddit

• made some other minor adjustments to the geometry (thicken drawer backplane for smooth opening)

Support the designer:

This design is free for the benefit of the community, but If you like my designs and want to contribute, you can make a donation to buymeacoffee  or paypal, or even better, join “My Club” here in printables.com, that will be greatly appreciated.