Samsung Galaxy Watch 4, 5, and 6 Charger Stand (Updated with support shelf)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A stand for the Samsung Galaxy Watch 4, 5, and 6 chargers
- Ocena
- 5 / 5
- Polubienia
- 49
- Pobrania
- 435
- Wydruki
- 4
- Wyświetlenia
- 2345
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A stand to fit the Samsung Galaxy Watch 6 charger that is slightly smaller than the watch 4 and 5 chargers.
Added a file for Watch 4 and 5 chargers.
I did these at 10% infill, add more infill to make them heavier and have better stability when the watch is on the charger.
I have noticed a difference in fitting between brands of printers, if yours is a little loose then use masking tape to shim it up better.
I have updated this with a small support shelf because sometimes the magnet isn't strong enough to hold a watch with a case on it. Shelf is at about 1 inch from center radius. (For the 47mm watch, I don't have the smaller watch to know the sizes needed on the outside Diameter with a case. Make a comment and let me know if you want a different size with your measurement and I'll adjust it.)
Added new files with a shorter shelf at 40 degrees instead of 60 to make room for watches with a cover.