1 / 5
Q Acoustics Bookshelf Speaker Feet
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A great solution if you're looking for improved isolation of your Q Acoustics bookshelf speakers.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 524
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial
These feet screw straight into 3xxx series bookshelf speakers. They make use of the existing rubber foot provided with your speakers and raise the speaker by 24mm in total.
Enjoy!
They should be compatible with the following speakers:
- 3010 & 3010i
- 3020 & 3020i
- 3030i
Assembly
- Print as many feet as needed for your requirements (in most cases 4)
- Remove the existing rubber feet from your speakers
- Press each rubber foot into the base of each printed foot
- This will be a tight fit, so a twisting motion might be needed
- Locate the feet holes on your speaker
- Screw each printed foot into each foot hole
- After several rotations, your printed foot should interface with the bottom of your speaker