1 / 6
Permanent J-Channel RGB Pixel Soffit hangers and Drill Guide — zdjęcie 1
1 / 6

Permanent J-Channel RGB Pixel Soffit hangers and Drill Guide

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

3D printed clips to attach WS2811 Pixels in J-Channel to the soffit for Permanent LED Lighting

Ocena
0 / 5
Polubienia
12
Pobrania
52
Wydruki
0
Wyświetlenia
1263
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial

3D printed clips to attach WS2811 Pixels in J-Channel to the soffit for Permanent LED Lighting.

Printing:

Clips: PETG or ASA - .3mm at 20% infill

Drill Guide: PLA - .3mm 20% infill stand on end (will fit on Prusa MK3s size printer)

 

Clip usage: 

For me the 7mm clip was the main one I used for going across the front of the house. Where the other heights came in is if your gutters drop on one side you can use the different height clips to drop the J-Channel so the lights are visible.

To attach slide the front tab in between the soffit and the lip it rests on and then use some small gutter screws (can get them in where you find the gutters at HomeDepot or Lowes) to screw the back in.

The Clip setter is a tool I made to make it easy to put the clips 12 inches apart (screw to screw). you adjust the spacing of the first clip so it in the center between your first and second pixel in the J-channel once you have it figure where your starting point is.

The 7mm Joiner is double wide to give support where J-Channels meet on long runs.

I put another J-channel with the small side curl cut off on the back side to box all the wiring in to give it a cleaner look.

Once you have all the Clips for a section up you can slip the J-channels in the clips and push a ziptie in the two rear slotts to hold them in place, then go back trough and fasten them and trim the tails off. Be careful you don't tighten the ziptie too much or it will break the clip. Also make sure you are using UV stabilzed ties.