Bud Spencer Bust - No Support Cut
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The model is split into segment to print it without support. It is increased to a height of 130mm total.
- Ocena
- 4,857 / 5
- Polubienia
- 31
- Pobrania
- 242
- Wydruki
- 8
- Wyświetlenia
- 2271
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Sculptures
- Licencja
- Creative Commons — Attribution — Noncommercial
The model is split into segment to print it without support.
It is increased to a height of 130mm total.
The sholder are cut back a bit to give it a better print angle of 55°.
To make the lineup for the gluing easier FilaPins are added to each cut.
For that you will need 6 peaces of 1.75mm filament which are 13mm long.
Therefore i do not suggest to scale the model.
Holes for additional FilaPins are added to the base for a pedestal.
Here is my design:
https://www.prusaprinters.org/prints/56209-pedestal-for-showpiece
If you like to crate your own stand use the FilaPin.stl to add the necessary
holes to your model.
Credits go to IronButterFly for the amazing sculpture of Terence Hill:
https://www.thingiverse.com/thing:3319743