Starship Koozie
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A modular drink koozie cut out from a Spacex Starship model.
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 108
- Wydruki
- 1
- Wyświetlenia
- 583
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Turned a Spacex Starship model into a beverage koozie. Includes starship bottom that fits an energy drink can, a can spacer so smaller cans are raised up, a bottle spacer so glass bottles don't move as much, and two starship tops, one with a straw hole.
I also included a test print to test tolerances of top and bottom fit and to test supports. Bottom is easier to print upside down to keep details of the engines but need decent support and brim around the bottom edge. The inside of the starship bottom should bridge just fine depending on printer but support blocker might be needed depending on slicer.
The starship top straw model will need support for the top of straw hole and bottom raised edge, use enough brim so model does not get knocked over.
I set support angle to above 75% overhang.
For the test fit parts, if you have to scale either top or bottom section, use the % for the corresponding part of the koozie. Current part spacing between top and bottom is 0.2mm. You can change XY expansion or hole size settings to grow or shrink the fitment of top and bottom.
Good luck and I can update parts if needed.