Malkemist

Malkemist release candidate - a Meaker remix of Sillybuts' Alchemist pump action blaster. Pretty sure I used the same license as he does. I may revisit in the future to take a bit more length off, but maybe not because I have all the physical versions I need now. Hardware:

• (2) 18” long 1/2”x1/8” alu bars
• (2) probably-TC sized alu bars; but (4) will fit from one 36” piece of stock (which was the goal - reduce stock requirements )
• A few #10x1-1/2” bolts
• A bunch of #4x1/2” sheet metal or similar screws
• 1/2 of a caliburn plunger tube
• Appropriate orings
• Includes a printed ramcore; haven’t had issues but maybe a regular one would work
• Assorted other bits: small springs, elastic, etc.
• 9” + barrel
• #10 short bolts for prime bars
• sized for some kind of bearing, but TBH the printed wheels are fine
• I could figure all this out in metric but it’s less work not to

TLDR: Beside the flatbars, springs, and bolts, which are readily accessible at most well-stocked hardware stores, one sillybow kit gives you parts for two blasters. Will I provide instruction or advice beyond this, the step, and an unsorted list of parts? Unlikely XD

Printed on a prusa mini. It wasn't picky, probably 4-6 walls though, minimum infill as usual for my builds.