Ortur LM 2 Pro S2 - Cable Support + Mount for 10W LU2-10A Laser Module
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I upgraded my Ortur LM2 Pro S2 with the new 10W LU2-10A Laser Module and needed something for cablemanagement
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 53
- Wydruki
- 0
- Wyświetlenia
- 691
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
I upgraded my Ortur LM2 Pro S2 with the new 10W LU2-10A laser module and needed something for cable management and a mount for the new circuit board that comes with the laser module. As additional information - our Ortur Laser is mounted inside the original Ortur Metal Case!
Thanks to @henchy_393989 I found his awesome cable support structure and finally modified it to my needs.
All you need are some zip ties, 2 new M3x10 screws on either side of the cable support parts and 2x M3x8 to hold the board in place. On this side I cut threads in the two holes. It will keep it neat later.
The right part also contains a hook that fits into the x-axis aluminum profile. This gives both parts enough support so they don't fall off when the cables are attached inside.
I think my pictures tell you everything you need.
Print with supports!
If you're wondering about my laser vent, I installed it on the right side of the case and made a matching mount for an additional 80mm fan. You can find these parts in my published parts.