1 / 2
Volkswagen A1 lower steering column bearing sleeve (Cabriolet, Golf Mk1, Scirocco) — zdjęcie 1
1 / 2

Volkswagen A1 lower steering column bearing sleeve (Cabriolet, Golf Mk1, Scirocco)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Lower steering column sleeve/bushing, part of VW part 171 419 517.

Ocena
0 / 5
Polubienia
17
Pobrania
145
Wydruki
0
Wyświetlenia
1188
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Share Alike

Summary

This sleeve/bushing is designed to replace the original plastic one, which is part of VW part number 171 419 517. The sleeve is the main part of this assembly that tends to disintegrate, making the steering column rattle against its tube. Replacement assemblies are not always easy to locate, so this can help you repair the one you already have.

Note: US vs European models

There may be differences between US and European versions of the steering column on these vehicles. This worked for me for my California-spec West German-built 1991 VW Cabriolet. Your mileage may vary.

How to use

If your original outer race and bearing are still good like mine were, clean them, grease them, and put them in this part, which compresses flush into the lower end of the steering column tube. I used normal lithium grease.

I originally installed this part to my 1991 VW Cabriolet in 2016, printed with PLA with 55% infill. It lasted 7 years, and I replaced it with a PETG-CF version in 2023.

Technical details

This is a repair part for a common problem with Volkswagen A1 platform vehicles (Golf Mk1, Cabriolet, Jetta Mk1, Caddy, Scirocco), related to the mating of the steering column shaft to the lower end of the tube that houses it.

When working properly, an inner race (compression fit to the shaft) spins in a pin bearing housed in an outer race, compression fit to the tube with a plastic bushing/sleeve. In practice, that plastic bushing tends to disintegrate, allowing the pin bearing to fall out, even though the inner race, outer race, and bearing are all just fine.

The outer race, bearing, and plastic sleeve all together form VW part number 171419517. The inner race and bushing together form VW part 171419518A.

This part is a 3D printable version the outer plastic sleeve, which people have variously bodged with PVC pipe, washers, hose clamps, and other solutions. See, for example, https://www.vwvortex.com/threads/diy-cheap-hillbilly-fix-dreaded-lower-steering-column-bearing-171419517-vw.6877201/.

The innter race can also have problems, with its inner plastic section disintegrating. I didn't have this issue, but some have also devised 3D printable solutions to that. See http://forums.vwvortex.com/showthread.php?7662865-Steering-column-bearing-New-trick-to-old-problem

Tech-53 also sells a kit to rebuild this interface, and their page has a great video describing how the assembly goes together. https://tech-53.com/product/lower-steering-column-rebuild-kit/

Tagi